Helm Conversion from Tiller to Wheel Cal 34

Hi Everyone Wondering if anyone has done this any pictures of info would be great. I already have the Pedistol Wheel compass chain and wire ordering quadrante and shaft packing this week. boat is out of the water and rudder is dropped have not made any cuts just yet as iam awaiting parts from edeson. Parts were late to order as i needed to be sure of shaft size before ordering them. Well this should be a pretty simple job planning on placeing the pedistal just behind the post for the tiller leaving just enough room to stand but just barrely.my boat is a 1968 haul # 104 i beleave. Planing on useing a Round Quadrant 16" diamiter and running the cables aft below deck then back foward to the quadrate as the pedital will be just about ontop of the tiller Crown (place where till attaches above deck) so any advise or toughts would could be help full I also plan to take lots of before and after pictures to help anyone else if they plan on doing this in future. Well Far seas and good winds to all.... Boat and I live Bay area CA